Thursday, August 18, 2016

Organic Carbon Fibre Masts, August 2016

Here is an update for August, 2016. I picked up my 
trees, and have done the rough work of converting them to "Organic Carbon Fibre" Masts. Of course, this is only going by what my high school biology teacher told me trees were made of, with a few years in between to make the memories a little fuzzy. Anyways, it is much easier to let Mother Nature do the layup of the carbon fibre than doing it myself.
Also had to build some heavy duty saw horses for this step.  
 I have the best pole completely power planed as the main mast, and the second best pole about 70% done, before the belt in my planer melted. I have just exchanged it on warranty, as the planer and replacement belt are discontinued, but one local store had some of the old stock still.
Next is to take the belt sander to  the poles, cut to length, and put on a coat of paint.
There is a third pole in case I find major flaws in the first two.
 I also bought two 50 gallon water tanks, here is a picture of the starboard tank in position, and at the bottom of the picture is a corner of a 4" deep 37x37" tray that will form my shower pan. The pan will get a sump pump and an elevated grating to stand on while showering.

Not shown is a 32 gallon tank that will be installed for grey water, when in a location that does not allow discharge.







I purchased the various fittings to fill and vent, as well as a 8" clean out with rubber seal for each tank. Once I have the tanks and bulkheads all figured out, I will cut and install the fittings

4 comments:

  1. Just looking at the photos of your masts made me tired! ;-) Nice.

    Where on the hull do you plan to install the graywater discharge outlets (for use when permitted)?

    ReplyDelete
  2. The grey water tank will be located at the back of the galley cabinet holding the sink, with the bottom of the tank about 16" above the sole. A pipe with valves will lead aft and exit under the boat on the curved portion of the hull. It will normally be above the waterline. I intend to have a fitting that will allow attaching a hose to drain it while out of the water

    ReplyDelete
  3. Looking great, Dennis!

    A friend used that shower arrangement, and loved it. Will you be sheathing the shower space all round? If so, I'm curious how you'll direct water into the tray... fit it like a hatch? Drip guides?

    I assume you're checking with your Coast Guard for regulations? Ours get mighty particular, once a system is installed, and it saves a lot of grief to go by their book!

    ReplyDelete
  4. I am thinking of using a product called puckboard,http://www.rona.ca/en/high-density-polyethylene-puck-board-4-x-8-55375103 used to line hockey rinks, and thinner versions as shower liners.
    The tray has a lip for the puckboard to overlap into.
    I read all the regulations I could find, and it appears that they just specify no discharge, I will make the exit thruhull lockable in the closed position, which should satisfy regulations. How else could a boat go from discharge allowed areas to non-allowed?

    ReplyDelete